AMPLOT(8) System Administration Commands AMPLOT(8)NAMEamplot - visualize the behavior of Amanda
SYNOPSISamplot [-b] [-c] [-e] [-g] [-l] [-p] [-t T] amdump_files
Amplot reads an amdump output file that Amanda generates each run (e.g.
amdump.1) and translates the information into a picture format that may
be used to determine how your installation is doing and if any
parameters need to be changed. Amplot also prints out amdump lines
that it either does not understand or knows to be warning or error
lines and a summary of the start, end and total time for each backup
Amplot is a shell script that executes an awk program (amplot.awk) to
scan the amdump output file. It then executes a gnuplot program
(amplot.g) to generate the graph. The awk program is written in an
enhanced version of awk, such as GNU awk (gawk(1) version 2.15 or
later) or nawk(1).
During execution, amplot generates a few temporary files that gnuplot
uses. These files are deleted at the end of execution.
See the amanda(8) man page for more details about Amanda.
Generate b/w postscript file (need -p).
Compress amdump_files after plotting.
Extend the X (time) axis if needed.
Direct gnuplot output directly to the X11 display (default).
Direct postscript output to file YYYYMMDD.ps (opposite of -g).
Generate landscape oriented output (needs -p).
Set the right edge of the plot to be T hours.
The amdump_files may be in various compressed formats (compress, gzip,
The figure is divided into a number of regions. There are titles on the
top that show important statistical information about the configuration
and from this execution of amdump. In the figure, the X axis is time,
with 0 being the moment amdump was started. The Y axis is divided into
QUEUES: How many backups have not been started, how many are waiting on
space in the holding disk and how many have been transferred
successfully to tape.
%BANDWIDTH: Percentage of allowed network bandwidth in use.
HOLDING DISK: The higher line depicts space allocated on the holding
disk to backups in progress and completed backups waiting to be written
to tape. The lower line depicts the fraction of the holding disk
containing completed backups waiting to be written to tape including
the file currently being written to tape. The scale is percentage of
the holding disk.
TAPE: Tape drive usage.
%DUMPERS: Percentage of active dumpers.
The idle period at the left of the graph is time amdump is asking the
machines how much data they are going to dump. This process can take a
while if hosts are down or it takes them a long time to generate
Reports lines it does not recognize, mainly error cases but some are
legitimate lines the program needs to be taught about.
SEE ALSOamanda(8), amdump(8), gnuplot(1), compress(1), gzip(1)
The Amanda Wiki: : http://wiki.zmanda.com/
Olafur Gudmundsson <firstname.lastname@example.org>
Trusted Information Systems
Stefan G. Weichinger <email@example.com>
Amanda 3.3.3 01/10/2013 AMPLOT(8)