APPLY(1) BSD General Commands Manual APPLY(1)NAMEapply — apply a command to a set of arguments
SYNOPSISapply [-ac] [-#] command argument ...
Apply runs the named command on each argument argument in turn.
Character sequences of the form “%d” in command, where “d” is a digit
from 1 to 9, are replaced by the d´th following unused argument. In this
case, the largest digit number of arguments are discarded for each execu‐
tion of command.
The options are as follows:
-# Normally arguments are taken singly; the optional number -# speci‐
fies the number of arguments to be passed to command. If the number
is zero, command is run, without arguments, once for each argument.
If any sequences of “%d” occur in command, the -n option is ignored.
-ac The use of the character “%” as a magic character may be changed
with the -a option.
The following environment variable affects the execution of apply:
SHELL Pathname of shell to use. If this variable is not defined, the
Bourne shell is used.
EXAMPLESapply echo a*
is similar to ls(1);
apply-2 cmp a1 b1 a2 b2 a3 b3
compares the `a' files to the `b' files;
apply-0 who 1 2 3 4 5
runs who(1) 5 times; and
apply ´ln %1 /usr/joe´ *
links all files in the current directory to the directory
/bin/sh Default shell
Shell metacharacters in command may have bizarre effects; it is best to
enclose complicated commands in single quotes (‘’).
The apply command appeared in 4.2BSD.
4.2 Berkeley Distribution April 4, 1994 4.2 Berkeley Distribution