IPSEC_ATOUL(3)IPSEC_ATOUL(3)NAME
ipsec atoul, ultoa - convert unsigned-long numbers to and from ASCII
SYNOPSIS
#include <freeswan.h>
const char *atoul(const char *src, size_t srclen,
int base, unsigned long *n);
size_t ultoa(unsigned long n, int base, char *dst,
size_t dstlen);
DESCRIPTION
These functions are obsolete; see ipsec_ttoul(3) for their replace‐
ments.
Atoul converts an ASCII number into a binary unsigned long value.
Ultoa does the reverse conversion, back to an ASCII version.
Numbers are specified in ASCII as decimal (e.g. 123), octal with a
leading zero (e.g. 012, which has value 10), or hexadecimal with a
leading 0x (e.g. 0x1f, which has value 31) in either upper or lower
case.
The srclen parameter of atoul specifies the length of the ASCII string
pointed to by src; it is an error for there to be anything else (e.g.,
a terminating NUL) within that length. As a convenience for cases
where an entire NUL-terminated string is to be converted, a srclen
value of 0 is taken to mean strlen(src).
The base parameter of atoul can be 8, 10, or 16, in which case the num‐
ber supplied is assumed to be of that form (and in the case of 16, to
lack any 0x prefix). It can also be 0, in which case the number is
examined for a leading zero or a leading 0x to determine its base, or
13 (halfway between 10 and 16), which has the same effect as 0 except
that a non-hexadecimal number is considered decimal regardless of any
leading zero.
The dstlen parameter of ultoa specifies the size of the dst parameter;
under no circumstances are more than dstlen bytes written to dst. A
result which will not fit is truncated. Dstlen can be zero, in which
case dst need not be valid and no result is written, but the return
value is unaffected; in all other cases, the (possibly truncated)
result is NUL-terminated.
The base parameter of ultoa must be 8, 10, or 16.
Atoul returns NULL for success and a pointer to a string-literal error
message for failure; see DIAGNOSTICS. Ultoa returns the size of buffer
which would be needed to accommodate the full conversion result,
including terminating NUL; it is the caller's responsibility to check
this against the size of the provided buffer to determine whether trun‐
cation has occurred.
SEE ALSOatol(3), strtoul(3)DIAGNOSTICS
Fatal errors in atoul are: empty input; unknown base; non-digit charac‐
ter found; number too large for an unsigned long.
HISTORY
Written for the FreeS/WAN project by Henry Spencer.
BUGS
There is no provision for reporting an invalid base parameter given to
ultoa.
The restriction of error reports to literal strings (so that callers
don't need to worry about freeing them or copying them) does limit the
precision of error reporting.
The error-reporting convention lends itself to slightly obscure code,
because many readers will not think of NULL as signifying success. A
good way to make it clearer is to write something like:
const char *error;
error = atoul( /* ... */ );
if (error != NULL) {
/* something went wrong */
11 June 2001 IPSEC_ATOUL(3)
