CAT(1) BSD General Commands Manual CAT(1)NAMEcat — concatenate and print files
SYNOPSIScat [-benstuv] [file ...]
The cat utility reads files sequentially, writing them to the standard
output. The file operands are processed in command-line order. If file
is a single dash (‘-’) or absent, cat reads from the standard input. If
file is a UNIX domain socket, cat connects to it and then reads it until
EOF. This complements the UNIX domain binding capability available in
The options are as follows:
-b Number the non-blank output lines, starting at 1.
-e Display non-printing characters (see the -v option), and display
a dollar sign (‘$’) at the end of each line.
-n Number the output lines, starting at 1.
-s Squeeze multiple adjacent empty lines, causing the output to be
-t Display non-printing characters (see the -v option), and display
tab characters as ‘^I’.
-u Disable output buffering.
-v Display non-printing characters so they are visible. Control
characters print as ‘^X’ for control-X; the delete character
(octal 0177) prints as ‘^?’. Non-ASCII characters (with the high
bit set) are printed as ‘M-’ (for meta) followed by the character
for the low 7 bits.
The cat utility exits 0 on success, and >0 if an error occurs.
will print the contents of file1 to the standard output.
cat file1 file2 > file3
will sequentially print the contents of file1 and file2 to the file
file3, truncating file3 if it already exists. See the manual page for
your shell (i.e., sh(1)) for more information on redirection.
cat file1 - file2 - file3
will print the contents of file1, print data it receives from the stan‐
dard input until it receives an EOF (‘^D’) character, print the contents
of file2, read and output contents of the standard input again, then
finally output the contents of file3. Note that if the standard input
referred to a file, the second dash on the command-line would have no
effect, since the entire contents of the file would have already been
read and printed by cat when it encountered the first ‘-’ operand.
SEE ALSOhead(1), more(1), pr(1), sh(1), tail(1), vis(1), zcat(1), setbuf(3)
Rob Pike, "UNIX Style, or cat-v Considered Harmful", USENIX Summer
Conference Proceedings, 1983.
The cat utility is compliant with the IEEE Std 1003.2-1992 (“POSIX.2”)
The flags [-benstv] are extensions to the specification.
A cat utility appeared in Version 1 AT&T UNIX. Dennis Ritchie designed
and wrote the first man page. It appears to have been cat(1).
Because of the shell language mechanism used to perform output redirect‐
ion, the command “cat file1 file2 > file1” will cause the original data
in file1 to be destroyed!
The cat utility does not recognize multibyte characters when the -t or -v
option is in effect.
BSD March 21, 2004 BSD