cxy(4)cxy(4)Namecxy - CXY08 communications interface
Syntax
device dhu0 at uba0 csr 0160440 flags 0x?? vector dhurint dhuxint
Description
A CXY08 provides eight communication lines with modem control adequate
for UNIX dialup use. The device behaves and looks just like a DHV11 and
is specified in the configuration line the same as a DHV11 device.
Each line attached to the CXY08 communications interface behaves as
described in and can be set to run at any of 16 speeds. See for the
encoding.
Bit i of flags can be specified for a device to say that a line is not
properly connected and that the line should be treated as hardwired
with carrier always present. Thus, specifying flags 0x04 in the speciā
fication of would cause line tty02 to be treated in this way.
The driver normally interrupts on each input character. The and
devices operate under the control of the driver.
Diagnostics
dhu%d: receive fifo overflow
The character input fifo overflowed before it could be serviced. This
can happen if a hard error occurs when the CPU is running with elevated
priority, as the system then prints a message on the console with
interrupts disabled. This can cause a few input characters to be lost
to users. It is not serious.
dhu%d:%d DMA ERROR
A DMA transfer error has occurred. The unit number and line number are
printed. This means that the channel indicated has failed to transfer
DMA data within 10.7 microseconds of the bus request being acknowledged
or that there is a memory parity error. This may cause a few output
characters to be lost.
dhu%d: DIAG. FAILURE
This indicates that the internal diagnostics have detected an error.
dhu%d: DHU HARDWARE ERROR. TX.DMA.START failed
The failed to clear the start bit. Normally, this is cleared to signal
that a DMA transfer has completed.
Files
Dialups
See Alsotty(4), MAKEDEV(8)cxy(4)