FWE(4) BSD Kernel Interfaces Manual FWE(4)NAMEfwe — Ethernet emulation driver for FireWire
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
Alternatively, to load the driver as a module at boot time, place the
following line in loader.conf(5):
The fwe driver provides non-standard Ethernet emulation over FireWire
firewire(4) and fwohci(4) must be configured in the kernel as well.
This driver exploits asynchronous stream over IEEE 1394 to carry Ethernet
frames. The stream channel can be specified by the
This driver supports polling(4) as well if it is compiled with the
SEE ALSOarp(4), firewire(4), fwip(4), fwohci(4), netintro(4), ng_ether(4),
polling(4), ifconfig(8), kldload(8), sysctl(8)HISTORY
The fwe device driver first appeared in FreeBSD 5.0.
The fwe driver and this manual page were written by Hidetoshi Shimokawa.
This driver emulates Ethernet in a very adhoc way and it does not reserve
a stream channel using an isochronous manager. Note that this driver
uses a protocol which is very different from RFC 2734 (IPv4 over IEEE
BSD July 16, 2005 BSD