FWIP(4) BSD Kernel Interfaces Manual FWIP(4)NAMEfwip — IP over FireWire driver
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
Alternatively, to load the driver as a module at boot time, place the
following lines in loader.conf(5):
The fwip driver provides standard IP over FireWire (IEEE 1394) based on
the protocols described in RFC 2734 and RFC 3146.
The firewire(4) and fwohci(4) drivers must be configured in the kernel as
This driver supports polling(4) as well if it is compiled with the
SEE ALSOarp(4), firewire(4), fwe(4), fwohci(4), netintro(4), polling(4),
ifconfig(8), kldload(8), sysctl(8)HISTORY
The fwip device driver first appeared in FreeBSD 5.3.
The fwip driver and this manual page were written by Doug Rabson, based
on earlier work by Hidetoshi Shimokawa.
This driver currently does not support the MCAP protocol for multicast IP
over FireWire. Multicast packets are treated as broadcast packets which
is sufficient for most trivial uses of multicast.
BSD July 16, 2005 BSD