HPTRR(4) BSD Kernel Interfaces Manual HPTRR(4)NAMEhptrr — HighPoint RocketRAID device driver
To compile this driver into the kernel, place the following line in your
kernel configuration file:
Alternatively, to load the driver as a module at boot time, place the
following line in loader.conf(5):
The following tunables are settable from the loader:
set to 0 to deny driver attach to chips with generic Marvell (non-High‐
Point) PCI identification. These chips are also supported by ata(4).
Some vendors are using same chips, but without providing RAID BIOS.
The hptrr driver provides support for HighPoint's RocketRAID based RAID
These devices support SATA/ATA disk drives and provide RAID0 (striping),
RAID1 (mirroring), and RAID5 functionality.
The hptrr driver supports the following RAID controllers:
· RocketRAID 172x series
· RocketRAID 174x series
· RocketRAID 2210
· RocketRAID 222x series
· RocketRAID 2240
· RocketRAID 230x series
· RocketRAID 231x series
· RocketRAID 232x series
· RocketRAID 2340
· RocketRAID 2522
The hptrr driver only works on the i386 and amd64 platforms as it
requires a binary blob object from the manufacturer which they only sup‐
ply for these platforms. The hptrr driver does not work on i386 with
This driver does not support the RR182x series controller. See the
hptmv(4) manual page for details on support.
This driver supersedes the older rr232x driver.
SEE ALSOata(4), cam(4), hptmv(4), loader(8)HISTORY
The hptrr device driver first appeared in FreeBSD 6.3.
The hptrr device driver was written by HighPoint Technologies, Inc., and
ported to FreeBSD by Scott Long. This manual page was written by David
The hptrr driver does not support manipulating the RAID from the OS,
RAIDs need to be set up from the on-board BIOS.
BSD November 8, 2009 BSD