KBDRATE(8) Linux Programmer's Manual KBDRATE(8)NAMEkbdrate - reset the keyboard repeat rate and delay time
SYNOPSISkbdrate [ -s ] [ -r rate ] [ -d delay ]
DESCRIPTIONkbdrate is used to change the keyboard repeat rate and delay time. The
delay is the amount of time that a key must be depressed before it will
start to repeat.
Using kbdrate without any options will reset the repeat rate to 10.9
characters per second (cps) and the delay to 250 milliseconds (ms) for
Intel- and M68K-based systems. These are the IBM defaults. On SPARC-
based systems it will reset the repeat rate to 5 cps and the delay to
OPTIONS-s Silent. No messages are printed.
Change the keyboard repeat rate to rate cps. For Intel-based
systems, the allowable range is from 2.0 to 30.0 cps. Only cer‐
tain, specific values are possible, and the program will select
the nearest possible value to the one specified. The possible
values are given, in characters per second, as follows: 2.0,
2.1, 2.3, 2.5, 2.7, 3.0, 3.3, 3.7, 4.0, 4.3, 4.6, 5.0, 5.5, 6.0,
6.7, 7.5, 8.0, 8.6, 9.2, 10.0, 10.9, 12.0, 13.3, 15.0, 16.0,
17.1, 18.5, 20.0, 21.8, 24.0, 26.7, 30.0. For SPARC-based sys‐
tems, the allowable range is from 0 (no repeat) to 50 cps.
Change the delay to delay milliseconds. For Intel-based sys‐
tems, the allowable range is from 250 to 1000 ms, in 250 ms
steps. For SPARC systems, possible values are between 10 ms and
1440 ms, in 10 ms steps.
-V Display a version number and exit.
Not all keyboards support all rates.
Not all keyboards have the rates mapped in the same way.
Setting the repeat rate on the Gateway AnyKey keyboard does not work.
If someone with a Gateway figures out how to program the keyboard,
please send mail to email@example.com.
All this is very architecture dependent. Nowadays kbdrate first tries
the KDKBDREP and KIOCSRATE ioctls. (The former usually works on an
m68k machine, the latter for SPARC.) When these ioctls fail an ioport
interface as on i386 is assumed.
Linux 1.1.19 22 June 1994 KBDRATE(8)