RBOOTD(8) BSD System Manager's Manual RBOOTD(8)NAMErbootd — HP remote boot server
SYNOPSISrbootd [-ad] [-i interface] [config_file]
The rbootd utility services boot requests from Hewlett-Packard worksta‐
tions over a local area network. All boot files must reside in the boot
file directory; further, if a client supplies path information in its
boot request, it will be silently stripped away before processing. By
default, rbootd only responds to requests from machines listed in its
The options are as follows:
-a Respond to boot requests from any machine. The configuration
file is ignored if this option is specified.
-d Run rbootd in debug mode. Packets sent and received are dis‐
played to the terminal.
Service boot requests on specified interface. If unspeci‐
fied, rbootd searches the system interface list for the low‐
est numbered, configured ``up'' interface (excluding loop‐
back). Ties are broken by choosing the earliest match.
Specifying config_file on the command line causes rbootd to use a differ‐
ent configuration file from the default.
The configuration file is a text file where each line describes a partic‐
ular machine. A line must start with a machine's Ethernet address fol‐
lowed by an optional list of boot file names. An Ethernet address is
specified in hexadecimal with each of its six octets separated by a
colon. The boot file names come from the boot file directory. The eth‐
ernet address and boot file(s) must be separated by white-space and/or
comma characters. A pound sign causes the remainder of a line to be
Here is a sample configuration file:
# ethernet addr boot file(s) comments
08:00:09:0:66:ad SYSHPBSD # snake (4.3BSD)
08:00:09:0:59:5b # vandy (anything)
8::9:1:C6:75 SYSHPBSD,SYSHPUX # jaguar (either)
Rbootd logs status and error messages via syslog(3). A startup message
is always logged, and in the case of fatal errors (or deadly signals) a
message is logged announcing the server's termination. In general, a
non-fatal error is handled by ignoring the event that caused it (e.g. an
invalid Ethernet address in the config file causes that line to be inval‐
The following signals have the specified effect when sent to the server
process using the kill(1) command:
SIGHUP Drop all active connections and reconfigure.
SIGUSR1 Turn on debugging, do nothing if already on.
SIGUSR2 Turn off debugging, do nothing if already off.
/dev/bpf# packet-filter device
/etc/rbootd.conf configuration file
/tmp/rbootd.dbg debug output
/usr/mdec/rbootd directory containing boot files
/var/run/rbootd.pid process id
SEE ALSOkill(1), socket(2), signal(3), syslog(3), rmp(4)BUGS
If multiple servers are started on the same interface, each will receive
and respond to the same boot packets.
BSD November 17, 2018 BSD