ripngd(1M)ripngd(1M)NAMEripngd - RIPng routing daemon for IPv6
SYNOPSIS
config_file] trace_options] [trace_file]
DESCRIPTION
is a routing daemon that works with Route Administration Manager (RAMD)
for IPv6. This routing daemon is an implementation of Routing Informa‐
tion Protocol for IPv6 defined in RFC 2080. is invoked automatically
if it is enabled in the configuration file.
Options
supports the following command-line options:
Parses the configuration file for syntax errors and terminates exits
with status 0 if the configuration file contains no error. In case of
any error, exits with a non-zero value. prints the configuration file
errors, if any, to the standard output.
Parses the configuration file for syntax errors and terminates
Specifies an alternate configuration file to be used by
By default, uses the configuration file.
Specifies that
runs as a normal process and not as a daemon process.
Specifies that
does not modify the kernel forwarding table. That is, will not
send route updates to ramd(1M).
Suppresses stderr messages of
This option suppresses informational messages which are normally
printed to the standard output, and log error messages through
syslogd(1M). By default, errors are logged in
Specifies a comma-separated list of trace options that
must be enabled when starting No space is allowed between this
option and its arguments.
See ramd.conf(4) for information on valid trace options and
tracing.
trace_file
Name of the file used by to log tracing information. If trace
options are specified without specifying a trace file, uses the
default trace file
Signal Processing
The following HP-UX signals can be used to control
Specifies to reread the configuration file. reads the configuration
file and reconfigures its policies.
Specifies that the current state of
be written to dump file
Graceful shutdown.
On receipt of attempts a graceful shutdown. removes all
protocol route from the kernel routing table upon receiv‐
ing
Toggle tracing.
If tracing is enabled, this signal suspends tracing and
closes the trace file. If tracing is disabled, opens the
trace file and initiates tracing. This is useful for mov‐
ing trace files.
cannot be used if does not enable tracing in the configu‐
ration file.
AUTHOR
was developed by Future Software Ltd.
SEE ALSOnetstat(1), ifconfig(1M), ram_monitor(1M), ramd(1M), rdc(1M), fork(2),
ramd.conf(4).
ripngd(1M)