SEEKDIR(P) POSIX Programmer's Manual SEEKDIR(P)PROLOG
This manual page is part of the POSIX Programmer's Manual. The Linux
implementation of this interface may differ (consult the corresponding
Linux manual page for details of Linux behavior), or the interface may
not be implemented on Linux.
NAMEseekdir - set the position of a directory stream
SYNOPSIS
#include <dirent.h>
void seekdir(DIR *dirp, long loc);
DESCRIPTION
The seekdir() function shall set the position of the next readdir()
operation on the directory stream specified by dirp to the position
specified by loc. The value of loc should have been returned from an
earlier call to telldir(). The new position reverts to the one associ‐
ated with the directory stream when telldir() was performed.
If the value of loc was not obtained from an earlier call to telldir(),
or if a call to rewinddir() occurred between the call to telldir() and
the call to seekdir(), the results of subsequent calls to readdir() are
unspecified.
RETURN VALUE
The seekdir() function shall not return a value.
ERRORS
No errors are defined.
The following sections are informative.
EXAMPLES
None.
APPLICATION USAGE
None.
RATIONALE
The original standard developers perceived that there were restrictions
on the use of the seekdir() and telldir() functions related to imple‐
mentation details, and for that reason these functions need not be sup‐
ported on all POSIX-conforming systems. They are required on implemen‐
tations supporting the XSI extension.
One of the perceived problems of implementation is that returning to a
given point in a directory is quite difficult to describe formally, in
spite of its intuitive appeal, when systems that use B-trees, hashing
functions, or other similar mechanisms to order their directories are
considered. The definition of seekdir() and telldir() does not specify
whether, when using these interfaces, a given directory entry will be
seen at all, or more than once.
On systems not supporting these functions, their capability can some‐
times be accomplished by saving a filename found by readdir() and later
using rewinddir() and a loop on readdir() to relocate the position from
which the filename was saved.
FUTURE DIRECTIONS
None.
SEE ALSOopendir() , readdir() , telldir() , the Base Definitions volume of
IEEE Std 1003.1-2001, <dirent.h>, <stdio.h>, <sys/types.h>
COPYRIGHT
Portions of this text are reprinted and reproduced in electronic form
from IEEE Std 1003.1, 2003 Edition, Standard for Information Technology
-- Portable Operating System Interface (POSIX), The Open Group Base
Specifications Issue 6, Copyright (C) 2001-2003 by the Institute of
Electrical and Electronics Engineers, Inc and The Open Group. In the
event of any discrepancy between this version and the original IEEE and
The Open Group Standard, the original IEEE and The Open Group Standard
is the referee document. The original Standard can be obtained online
at http://www.opengroup.org/unix/online.html .
IEEE/The Open Group 2003 SEEKDIR(P)
