GETITIMER(2) BSD System Calls Manual GETITIMER(2)NAME
getitimer, setitimer — get/set value of interval timer
LIBRARY
Standard C Library (libc, -lc)
SYNOPSIS
#include <sys/time.h>
#define ITIMER_REAL 0
#define ITIMER_VIRTUAL 1
#define ITIMER_PROF 2
int
getitimer(int which, struct itimerval *value);
int
setitimer(int which, const struct itimerval *value,
struct itimerval *ovalue);
DESCRIPTION
The system provides each process with three interval timers, defined in
<sys/time.h>. The getitimer() call returns the current value for the
timer specified in which in the structure at value. The setitimer() call
sets a timer to the specified value (returning the previous value of the
timer if ovalue is non-nil).
A timer value is defined by the itimerval structure:
struct itimerval {
struct timeval it_interval; /* timer interval */
struct timeval it_value; /* current value */
};
If it_value is non-zero, it indicates the time to the next timer expira‐
tion. If it_interval is non-zero, it specifies a value to be used in
reloading it_value when the timer expires. Setting it_value to 0 dis‐
ables a timer, regardless of the value of it_interval. Setting
it_interval to 0 causes a timer to be disabled after its next expiration
(assuming it_value is non-zero).
Time values smaller than the resolution of the system clock are rounded
up to this resolution (typically 10 milliseconds).
The ITIMER_REAL timer decrements in real time. A SIGALRM signal is
delivered when this timer expires.
The ITIMER_VIRTUAL timer decrements in process virtual time. It runs
only when the process is executing. A SIGVTALRM signal is delivered when
it expires.
The ITIMER_PROF timer decrements both in process virtual time and when
the system is running on behalf of the process. It is designed to be
used by interpreters in statistically profiling the execution of inter‐
preted programs. Each time the ITIMER_PROF timer expires, the SIGPROF
signal is delivered. Because this signal may interrupt in-progress sys‐
tem calls, programs using this timer must be prepared to restart inter‐
rupted system calls.
The maximum number of seconds allowed for it_interval and it_value in
setitimer() is 100000000.
NOTES
Three macros for manipulating time values are defined in <sys/time.h>.
Timerclear sets a time value to zero, timerisset tests if a time value is
non-zero, and timercmp compares two time values.
RETURN VALUES
Upon successful completion, the value 0 is returned; otherwise the
value -1 is returned and the global variable errno is set to indicate the
error.
ERRORSGetitimer() and setitimer() will fail if:
[EFAULT] The value parameter specified a bad address.
[EINVAL] A value parameter specified a time that was too large
to be handled.
SEE ALSOgettimeofday(2), select(2), sigvec(2), clocks(7)HISTORY
The getitimer() function call appeared in 4.2BSD.
BSD May 16, 1995 BSD
