BLOCKDEV(8) System Administration BLOCKDEV(8)NAMEblockdev - call block device ioctls from the command line
SYNOPSISblockdev [-q] [-v] command [command...] device [device...]
The utility blockdev allows one to call block device ioctls from the
OPTIONS-V Print version and exit.
-q Be quiet.
-v Be verbose.
Print a report for the specified device. It is possible to give
multiple devices. If none is given, all devices which appear in
/proc/partitions are shown. Note that the partition StartSec is
in 512-byte sectors.
It is possible to give multiple devices and multiple commands.
Get alignment offset.
Print blocksize in bytes.
Get discard zeroes support status.
Get filesystem readahead in 512-byte sectors.
Get minimum I/O size.
Get optimal I/O size.
Get max sectors per request
Get physical block (sector) size.
Print readahead (in 512-byte sectors).
Get read-only. Print 1 if the device is read-only, 0 otherwise.
Print device size in bytes.
Print device size (32-bit!) in sectors. Deprecated in favor of
the --getsz option.
Print sectorsize in bytes - usually 512.
Get size in 512-byte sectors.
Reread partition table
Set blocksize. Note that the block size is specific to the cur‐
rent file descriptor opening the block device, so the change of
block size only persists for as long as blockdev has the device
open, and is lost once blockdev exits.
Set filesystem readahead (same like --setra on 2.6 kernels).
Set readahead (in 512-byte sectors).
AUTHORblockdev was written by Andries E. Brouwer and rewritten by Karel Zak.
The blockdev command is part of the util-linux package and is available
util-linux August 2010 BLOCKDEV(8)