CONTINUE(1P) POSIX Programmer's Manual CONTINUE(1P)PROLOG
This manual page is part of the POSIX Programmer's Manual. The Linux
implementation of this interface may differ (consult the corresponding
Linux manual page for details of Linux behavior), or the interface may
not be implemented on Linux.
NAMEcontinue - continue for, while, or until loop
The continue utility shall return to the top of the smallest enclosing
for, while, or until loop, or to the top of the nth enclosing loop, if
n is specified. This involves repeating the condition list of a while
or until loop or performing the next assignment of a for loop, and re-
executing the loop if appropriate.
The value of n is a decimal integer greater than or equal to 1. The
default shall be equivalent to n=1. If n is greater than the number of
enclosing loops, the outermost enclosing loop shall be used.
See the DESCRIPTION.
The standard error shall be used only for diagnostic messages.
0 Successful completion.
>0 The n value was not an unsigned decimal integer greater than or
equal to 1.
CONSEQUENCES OF ERRORS
The following sections are informative.
for i in *
if test -d "$i"
echo "\"$i\"" is not a directory.
Special Built-In Utilities
Portions of this text are reprinted and reproduced in electronic form
from IEEE Std 1003.1, 2003 Edition, Standard for Information Technology
-- Portable Operating System Interface (POSIX), The Open Group Base
Specifications Issue 6, Copyright (C) 2001-2003 by the Institute of
Electrical and Electronics Engineers, Inc and The Open Group. In the
event of any discrepancy between this version and the original IEEE and
The Open Group Standard, the original IEEE and The Open Group Standard
is the referee document. The original Standard can be obtained online
at http://www.opengroup.org/unix/online.html .
IEEE/The Open Group 2003 CONTINUE(1P)