NETXML-UPS(8) NUT Manual NETXML-UPS(8)NAMEnetxml-ups - Driver for Eaton / MGE Network Management Card / Proxy
(XML/HTTP Protocol) equipment
NOTE
This man page only documents the hardware-specific features of the
netxml-ups driver. For information about the core driver, see
nutupsdrv(8).
SUPPORTED HARDWAREnetxml-ups support all recent Eaton / MGE models which use a Network
Management Card or Proxy (MGE XML/HTTP protocol based). This applies to
both Eaton (previously MGE Office Protection Systems) and to MGE UPS
SYSTEMS. Supported card and proxy models are:
· NMC Minislot (Ref 66102, firmware EA or newer),
· SNMP/Web Minislot card (Ref 66244)
· NMC Transverse (Ref 66074),
· NMC & Modbus/JBus (Ref 66103),
· Network Management Proxy,
· ePDU Monitored (newer version).
Older models, such as SNMP card (Ref 66062 and Ref 66045), use the SNMP
protocol and should use the snmp-ups(8) driver with the "mibs=mge"
parameter.
EXTRA ARGUMENTS
This driver supports the following optional settings in the
ups.conf(5):
timeout=value
The timeout for connecting to and reading from the UPS. Defaults to
5 seconds. Don’t change this value unless you know exactly what
you’re doing.
This value must never be higher than half the MAXAGE value specified in
upsd.conf(5), otherwise you run the risk that upsd(8) declares the
driver stale while it is waiting for a connection to timeout.
login=value
Set the login value for authenticated mode. This feature also needs
the password argument, and allows value settings in the card. This
feature is not used yet.
password=value
Set the password value, needed with the login for authenticated
mode. This feature is not used yet.
IMPLEMENTATION
The hostname of the UPS is specified with the "port" value in ups.conf,
i.e.:
[mgexml]
driver = netxml-ups
port = http://netxml-ups.example.com:80
Specifying the method to connect to the UPS (http, https) is mandatory.
If the port is equal to the default for the method specified (80 for
http, 443 for https) it may be omitted.
In order not to overload older NMCs by polling them too frequently, it
is recommended to increase the "pollinterval" (see nutupsdrv(8)) and
ups.conf(5)) to at least 5 seconds.
KNOWN ISSUES
Don’t connect to the UPS through a proxy. Although it would be trivial
to add support for proxies, this is not recommended and don’t ask for
it. Not only because it will prevent the driver to make a persistent
connection to the UPS, but also it adds an additional failure mode. If
the proxy goes down (for whatever reason), the driver will no longer be
able to reach the UPS.
AUTHORS
Arjen de Korte <adkorte-guest@alioth.debian.org>
SEE ALSO
The core driver:
nutupsdrv(8)
Internet resources:
The NUT (Network UPS Tools) home page: http://www.networkupstools.org/
Network UPS Tools 09/15/2011 NETXML-UPS(8)
