TRACE-CMD-SPLIT(1) [FIXME: manual] TRACE-CMD-SPLIT(1)NAMEtrace-cmd-split - split a trace.dat file into smaller files
SYNOPSIS
trace-cmd split [OPTIONS] [start-time [end-time]]
DESCRIPTION
The trace-cmd(1) split is used to break up a trace.dat into small
files. The start-time specifies where the new file will start at. Using
trace-cmd-report(1) and copying the time stamp given at a particular
event, can be used as input for either start-time or end-time. The
split will stop creating files when it reaches an event after end-time.
If only the end-time is needed, use 0.0 as the start-time.
If start-time is left out, then the split will start at the beginning
of the file. If end-time is left out, then split will continue to the
end unless it meets one of the requirements specified by the options.
OPTIONS-i file
If this option is not specified, then the split command will look
for the file named trace.dat. This options will allow the reading
of another file other than trace.dat.
-o file
By default, the split command will use the input file name as a
basis of where to write the split files. The output file will be
the input file with an attached ´.#\´ to the end: trace.dat.1,
trace.dat.2, etc.
This option will change the name of the base file used.
-o file will create file.1, file.2, etc.
-s seconds
This specifies how many seconds should be recorded before the new
file should stop.
-m milliseconds
This specifies how many milliseconds should be recorded before the
new file should stop.
-u microseconds
This specifies how many microseconds should be recorded before the
new file should stop.
-e events
This specifies how many events should be recorded before the new
file should stop.
-p pages
This specifies the number of pages that should be recorded before
the new file should stop.
Note: only one of *-p*, *-e*, *-u*, *-m*, *-s* may be specified at a time.
-r
This option causes the break up to repeat until end-time is reached
(or end of the input if end-time is not specified).
trace-cmd split -r -e 10000
This will break up trace.dat into several smaller files, each with at most
10,000 events in it.
-c
This option causes the above break up to be per CPU.
trace-cmd split -c -p 10
This will create a file that has 10 pages per each CPU from the input.
SEE ALSOtrace-cmd(1), trace-cmd-record(1), trace-cmd-report(1),
trace-cmd-start(1), trace-cmd-stop(1), trace-cmd-extract(1),
trace-cmd-reset(1), trace-cmd-list(1), trace-cmd-listen(1)AUTHOR
Written by Steven Rostedt, <rostedt@goodmis.org[1]>
RESOURCES
git://git.kernel.org/pub/scm/linux/kernel/git/rostedt/trace-cmd.git
COPYING
Copyright (C) 2010 Red Hat, Inc. Free use of this software is granted
under the terms of the GNU Public License (GPL).
NOTES
1. rostedt@goodmis.org
mailto:rostedt@goodmis.org
[FIXME: source] 02/21/2013 TRACE-CMD-SPLIT(1)
