TSORT(1) OpenBSD Reference Manual TSORT(1)NAMEtsort - topological sort of a directed graph
SYNOPSIStsort [-flqrvw] [-h file] [file]
DESCRIPTIONtsort takes a list of pairs of node names representing directed arcs in a
graph and prints the nodes in topological order on standard output. That
is, the input describes a partial ordering relation, from which tsort
computes a total order compatible with this partial ordering.
Input is taken from the named file, or from standard input if no file is
given.
Node names in the input are separated by white space and there must be an
even number of node pairs.
Presence of a node in a graph can be represented by an arc from the node
to itself. This is useful when a node is not connected to any other
nodes.
If the graph contains a cycle (and therefore cannot be properly sorted),
one of the arcs in the cycle is ignored and the sort continues. Cycles
are reported on standard error.
The options are as follows:
-f Resolve ambiguities by selecting nodes based on the order of
appearance of the first component of the pairs.
-h file
Use file, which holds an ordered list of nodes, to resolve
ambiguities. In case of duplicates, the first entry is chosen.
-l Search for and display the longest cycle. Can take a very long
time, as it may need to solve an NP-complete problem.
-q Do not display informational messages about cycles. This is
primarily intended for building libraries, where optimal ordering
is not critical, and cycles occur often.
-r Reverse the ordering relation.
-v Inform on the exact number of edges broken while breaking cycles.
If a hints file was used, inform on seen nodes absent from that
file.
-w Exit with exit code the number of cycles tsort had to break.
EXIT STATUS
The tsort utility exits 0 on success, and >0 if an error occurs.
EXAMPLES
Faced with the input:
a b
b c
b d
d f
c e
tsort outputs:
a
b
c
e
d
f
which is one total ordering compatible with the individual relations.
There is no unicity, another compatible total ordering would be:
a
b
c
d
e
f
tsort is commonly used to analyze dependencies and find a correct build
order in a static way, whereas make(1) accomplishes the same task in a
dynamic way.
SEE ALSOar(1), lorder(1), make(1)
Donald E. Knuth, The Art of Computer Programming, Vol. 1, pp 258-268,
1973.
STANDARDS
The tsort utility is compliant with the IEEE Std 1003.1-2008 (``POSIX'')
specification.
The flags [-fhlqrvw] are extensions to that specification.
HISTORY
A tsort command appeared in Version 7 AT&T UNIX. This tsort command was
completely rewritten by Marc Espie for OpenBSD, to finally use the well-
known optimal algorithms for topological sorting.
OpenBSD 4.9 September 3, 2010 OpenBSD 4.9
