FPA(4) BSD Kernel Interfaces Manual FPA(4)NAME
fpa, fea — device drivers for DEC FDDI controllers
The fpa and fea device drivers provide support for the DEC DEFPA PCI FDDI
Controller and the DEC DEFEA EISA FDDI Controller, respectively. All
variants of either controller are supported including the DAS and SAS
fea%d: error: desired IRQ of %d does not match device's actual IRQ (%d)
The device probe detected that the DEFEA board is configured for a dif‐
ferent interrupt than the one specified in the kernel configuration file.
fea%d: error: memory not enabled! ECU reconfiguration required The
device probe found that no device memory had been configured on the
DEFEA. Although the DEFEA can be configured with no device memory, this
driver requires a minimum of 1K device memory to be set up. The ECU
(EISA Configuration Utility) will need to be run to change the settings.
Normally, the device driver will not enable the reception of SMT frames.
However if the IFF_LINK1 flag is set, the device driver will enable the
reception of SMT frames and pass them up to the Berkeley Packet Filter
SEE ALSOarp(4), netintro(4), ifconfig(8)AUTHORS
The fpa and fea device drivers and this manual page were written by Matt
BSD March 13, 1995 BSD