GETTY(8) BSD System Manager's Manual GETTY(8)NAMEgetty — set terminal mode
SYNOPSISgetty [type [tty]]
The getty utility is called by init(8) to open and initialize the tty
line, read a login name, and invoke login(1).
The argument tty is the special device file in /dev to open for the ter‐
minal (for example, ``ttyh0''). If there is no argument or the argument
is ‘-’, the tty line is assumed to be open as file descriptor 0.
The type argument can be used to make getty treat the terminal line spe‐
cially. This argument is used as an index into the gettytab(5) database,
to determine the characteristics of the line. If there is no argument,
or there is no such table, the default table is used. If there is no
/etc/gettytab a set of system defaults is used. If indicated by the ta‐
ble located, getty will clear the terminal screen, print a banner head‐
ing, and prompt for a login name. Usually either the banner or the login
prompt will include the system hostname.
Most of the default actions of getty can be circumvented, or modified, by
a suitable gettytab table.
The getty utility can be set to timeout after some interval, which will
cause dial up lines to hang up if the login name is not entered reason‐
ttyxx: No such device or address.
ttyxx: No such file or address.
A terminal which is turned on in the ttys file cannot be opened, likely
because the requisite lines are either not configured into the system,
the associated device was not attached during boot-time system configura‐
tion, or the special file in /dev does not exist.
SEE ALSOlogin(1), ioctl(2), tty(4), gettytab(5), ttys(5), init(8)HISTORY
A getty utility appeared in Version 6 AT&T UNIX.
BSD June 4, 1993 BSD