ieee80211_input_all man page on FreeBSD

Man page or keyword search:  
man Server   9747 pages
apropos Keyword Search (all sections)
Output format
FreeBSD logo
[printable version]

IEEE80211_INPUT(9)	 BSD Kernel Developer's Manual	    IEEE80211_INPUT(9)

     ieee80211_input — software 802.11 stack input functions

     #include <net80211/ieee80211_var.h>

     ieee80211_input(struct ieee80211_node *, struct mbuf *, int rssi,
	 int noise);

     ieee80211_input_all(struct ieee80211com *, struct mbuf *, int rssi,
	 int noise);

     The net80211 layer that supports 802.11 device drivers requires that
     receive processing be single-threaded.  Typically this is done using a
     dedicated driver taskqueue(9) thread.  ieee80211_input() and
     ieee80211_input_all() process received 802.11 frames and are designed for
     use in that context; e.g. no driver locks may be held.

     The frame passed up in the mbuf must have the 802.11 protocol header at
     the front; all device-specific information and/or PLCP must be removed.
     Any CRC must be stripped from the end of the frame.  The 802.11 protocol
     header should be 32-bit aligned for optimal performance but receive pro‐
     cessing does not require it.  If the frame holds a payload and that is
     not aligned to a 32-bit boundary then the payload will be re-aligned so
     that it is suitable for processing by protocols such as ip(4).

     If a device (such as ath(4)) inserts padding after the 802.11 header to
     align the payload to a 32-bit boundary the IEEE80211_C_DATAPAD capability
     must be set.  Otherwise header and payload are assumed contiguous in the
     mbuf chain.

     If a received frame must pass through the A-MPDU receive reorder buffer
     then the mbuf must be marked with the M_AMPDU flag.  Note that for the
     moment this is required of all frames received from a station and TID
     where a Block ACK stream is active, not just A-MPDU aggregates.  It is
     sufficient to check for IEEE80211_NODE_HT in the ni_flags of the sta‐
     tion's node table entry, any frames that do not require reorder process‐
     ing will be dispatched with only minimal overhead.

     The rssi parameter is the Receive Signal Strength Indication of the frame
     measured in 0.5dBm units relative to the noise floor.  The noise parame‐
     ter is the best approximation of the noise floor in dBm units at the time
     the frame was received.  RSSI and noise are used by the net80211 layer to
     make scanning and roaming decisions in station mode and to do auto chan‐
     nel selection for hostap and similar modes.  Otherwise the values are
     made available to user applications (with the rssi presented as a fil‐
     tered average over the last ten values and the noise floor the last
     reported value).


BSD				August 4, 2009				   BSD

List of man pages available for FreeBSD

Copyright (c) for man pages and the logo by the respective OS vendor.

For those who want to learn more, the polarhome community provides shell access and support.

[legal] [privacy] [GNU] [policy] [cookies] [netiquette] [sponsors] [FAQ]
Polarhome, production since 1999.
Member of Polarhome portal.
Based on Fawad Halim's script.
Vote for polarhome
Free Shell Accounts :: the biggest list on the net