if_le man page on FreeBSD

Man page or keyword search:  
man Server   9747 pages
apropos Keyword Search (all sections)
Output format
FreeBSD logo
[printable version]

LE(4)			 BSD Kernel Interfaces Manual			 LE(4)

NAME
     le — AMD Am7900 LANCE and Am79C9xx ILACC/PCnet Ethernet interface driver

SYNOPSIS
     To compile this driver into the kernel, place the following line in your
     kernel configuration file:

	   device le

     Alternatively, to load the driver as a module at boot time, place the
     following line in loader.conf(5):

	   if_le_load="YES"

     For C-Bus non-PnP adapters, the port address and the IRQ number have to
     be specified in /boot/device.hints:
     hint.le.0.at="isa"
     hint.le.0.port="0x03d0"
     hint.le.0.irq="6"

     For ISA non-PnP adapters, the port address as well as the IRQ and the DRQ
     numbers have to be specified in /boot/device.hints:
     hint.le.0.at="isa"
     hint.le.0.port="0x280"
     hint.le.0.irq="10"
     hint.le.0.drq="0"

DESCRIPTION
     The le driver provides support for Ethernet adapters based on the AMD
     Am7990 and Am79C90 (CMOS, pin-compatible) Local Area Network Controller
     for Ethernet (LANCE) chips.

     The le driver also supports Ethernet adapters based on the AMD Am79C900
     Integrated Local Area Communications Controller (ILACC) as well as the
     Am79C9xx PCnet family of chips, which are single-chip implementations of
     a LANCE chip and a DMA engine.  This includes a superset of the PCI bus
     Ethernet chips supported by the pcn(4) driver.  The le driver treats all
     of these PCI bus Ethernet chips as an AMD Am79C970 PCnet-PCI and does not
     support the additional features like the MII bus and burst mode of AMD
     Am79C971 PCnet-FAST and greater chips.  Thus the pcn(4) driver should be
     preferred for the latter.

     Generally, the le driver aims at supporting as many different chips on as
     many different platforms as possible, partially at the cost of the best
     performance with some of these.

     The le driver supports reception and transmission of extended frames for
     vlan(4).  Selective reception of multicast Ethernet frames is provided by
     a 64-bit mask; multicast destination addresses are hashed to a bit entry
     using the Ethernet CRC function.

HARDWARE
   C-Bus and ISA
     The le driver supports C-Bus and ISA bus Ethernet adapters which are
     based on the following chips:

     ·	 AMD Am7990 and Am79C90 LANCE
     ·	 AMD Am79C960 PCnet-ISA
     ·	 AMD Am79C961 PCnet-ISA+
     ·	 AMD Am79C961A PCnet-ISA II

     This includes support for the following Ethernet adapters:

     C-Bus non-PnP:

     ·	 Contec C-NET(98)S

     ISA non-PnP:

     ·	 BICC Isolan
     ·	 Novell NE2100

     ISA PnP:

     ·	 AMD AM1500T/AM2100
     ·	 AMD PCnet-32
     ·	 AMD PCnet-ISA
     ·	 Allied Telesyn AT-1500
     ·	 Boca LANCard Combo
     ·	 Cabletron E2100 Series DNI
     ·	 Cabletron E2200 Single Chip
     ·	 Melco Inc. LGY-IV
     ·	 Novell NE2100
     ·	 Racal InterLan EtherBlaster

     The le driver does not support the selection of media types and options
     via ifconfig(8) with C-Bus and ISA bus Ethernet adapters.

   PCI
     The PCI bus Ethernet chips supported by the le driver are:

     ·	 AMD Am53C974/Am79C970/Am79C974 PCnet-PCI
     ·	 AMD Am79C970A PCnet-PCI II
     ·	 AMD Am79C971 PCnet-FAST
     ·	 AMD Am79C972 PCnet-FAST+
     ·	 AMD Am79C973/Am79C975 PCnet-FAST III
     ·	 AMD Am79C976 PCnet-PRO
     ·	 AMD Am79C978 PCnet-Home

     This includes support for the following Ethernet adapters:

     ·	 AcerLAN NIC P20
     ·	 Allied Telesyn AT-2450 and AT-2700 series
     ·	 VMware emulated AMD Am79C970A PCnet-PCI II interface

     The le driver supports the selection of the following media types via
     ifconfig(8) with PCI bus Ethernet adapters:

     autoselect	  Enable autoselection of the media type.

     10baseT/UTP  Select UTP media.

     10base5/AUI  Select AUI/BNC media.

     The following media option is supported with these media types:

     full-duplex  Select full duplex operation.

     Note that unlike the pcn(4) driver, the le driver does not support
     selecting 100Mbps (Fast Ethernet) media types.

   sparc64
     The le driver supports the on-board LANCE interfaces found in Sun Ultra 1
     machines.	The le driver allows the selection of the following media
     types via ifconfig(8) with these on-board interfaces:

     autoselect	  Enable autoselection of the media type.

     10baseT/UTP  Select UTP media.

     10base5/AUI  Select AUI media.

     When using autoselection, a default media type is selected for use by
     examining all ports for carrier.  The first media type with which a car‐
     rier is detected will be selected.	 Additionally, if carrier is dropped
     on a port, the driver will switch between the possible ports until one
     with carrier is found.

     The le driver also supports the following Sun SBus Ethernet add-on
     adapters:

     ·	 SCSI HBA and Buffered Ethernet (SBE/S, P/N 501-1869)
     ·	 Fast SCSI and Buffered Ethernet (FSBE/S, P/N 501-2015 and 501-2981)

     The le driver does not support the selection of media types and options
     via ifconfig(8) with SBus Ethernet add-on adapters.

     For further information on configuring media types and options, see
     ifconfig(8).

DIAGNOSTICS
     le%d: overflow  More packets came in from the Ethernet than there was
     space in the LANCE receive buffers.  Packets were missed.

     le%d: receive buffer error	 The LANCE ran out of buffer space, packet
     dropped.

     le%d: lost carrier	 The Ethernet carrier disappeared during an attempt to
     transmit.	The LANCE will finish transmitting the current packet, but
     will not automatically retry transmission if there is a collision.

     le%d: excessive collisions, tdr %d	 The Ethernet was extremely busy or
     jammed, outbound packets were dropped after 16 attempts to retransmit.

     TDR is the abbreviation of "Time Domain Reflectometry".  The optionally
     reported TDR value is an internal counter of the interval between the
     start of a transmission and the occurrence of a collision.	 This value
     can be used to determine the distance from the Ethernet tap to the point
     on the Ethernet cable that is shorted or open (unterminated).

     le%d: dropping chained buffer  A packet did not fit into a single receive
     buffer and was dropped.  Since the le driver allocates buffers large
     enough to receive maximum sized Ethernet packets, this means some other
     station on the LAN transmitted a packet larger than allowed by the Ether‐
     net standard.

     le%d: transmit buffer error  The LANCE ran out of buffer space before
     finishing the transmission of a packet.  If this error occurs, the driver
     software has a bug.

     le%d: underflow  The LANCE ran out of buffer space before finishing the
     transmission of a packet.	If this error occurs, the driver software has
     a bug.

     le%d: controller failed to initialize  Driver failed to start the LANCE.
     This is potentially a hardware failure.

     le%d: memory error	 RAM failed to respond within the timeout when the
     LANCE wanted to read or write it.	This is potentially a hardware fail‐
     ure.

     le%d: receiver disabled  The receiver of the LANCE was turned off due to
     an error.

     le%d: transmitter disabled	 The transmitter of the LANCE was turned off
     due to an error.

SEE ALSO
     altq(4), arp(4), intro(4), netintro(4), pcn(4), vlan(4), ifconfig(8)

HISTORY
     The le driver was ported from NetBSD and first appeared in FreeBSD 6.1.
     The NetBSD version in turn was derived from the le driver which first
     appeared in 4.4BSD.

AUTHORS
     The le driver was ported by Marius Strobl ⟨marius@FreeBSD.org⟩.

BSD			       January 20, 2007				   BSD
[top]

List of man pages available for FreeBSD

Copyright (c) for man pages and the logo by the respective OS vendor.

For those who want to learn more, the polarhome community provides shell access and support.

[legal] [privacy] [GNU] [policy] [cookies] [netiquette] [sponsors] [FAQ]
Tweet
Polarhome, production since 1999.
Member of Polarhome portal.
Based on Fawad Halim's script.
...................................................................
Vote for polarhome
Free Shell Accounts :: the biggest list on the net