FPA(4) OpenBSD Programmer's Manual FPA(4)NAME
fpa, fea, fta - DEC DEFPA/DEFEA/DEFTA FDDI network device
SYNOPSIS
fpa* at pci?
fea* at eisa?
fta* at tc?
DESCRIPTION
The fpa, fea, and fta device drivers provide support for the DEC DEFPA
PCI FDDI, DEC DEFEA EISA FDDI and DEC DEFTA TURBOchannel FDDI
Controllers, respectively. All variants of either controller are
supported including the DAS and SAS configurations.
DIAGNOSTICS
fea%d: error: desired IRQ of %d does not match device's actual IRQ
(%d) The device probe detected that the DEFEA board is configured for a
different interrupt than the one specified in the kernel configuration
file.
fea%d: error: memory not enabled! ECU reconfiguration required The
device probe found that no device memory had been configured on the
DEFEA. The DEFEA can be configured with no device memory, this driver
requires a minimum of 1K device memory be set up. The ECU (EISA
Configuration Utility) will need to be run to change the settings.
SEE ALSOarp(4), eisa(4), intro(4), netintro(4), pci(4), ifconfig(8)AUTHORS
The fpa, fea, and fta device driver and manual page were written by Matt
Thomas.
CAVEATS
Normally, the device driver will not enable the reception of SMT frames.
However if the IFF_LINK1 flag is set, the device driver will enable the
reception of SMT frames and pass them up to the Berkeley Packet Filter
for processing.
OpenBSD 4.9 December 13, 2009 OpenBSD 4.9