HPFTODIT(1)HPFTODIT(1)NAMEhpftodit - create font description files for use with groff -Tlj4
SYNOPSIShpftodit [ -sv ] [ -in ] tfm_file map_file font
It is possible to have whitespace between the -i command line option
and its parameter.
DESCRIPTIONhpftodit creates a font file for use with groff -Tlj4 from an HP tagged
font metric file. tfm_file is the name of the tagged font metric file
for the font. map_file is a file giving the groff names for characters
in the font; this file should consist of a sequence of lines of the
n c1 c2 ...
where n is a decimal integer giving the MSL number of the character,
and c1, c2,... are the groff names of the character. font is the name
of the groff font file. The groff font file is written to font.
The -s option should be given if the font is special (a font is special
if troff should search it whenever a character is not found in the cur‐
rent font.) If the font is special, it should be listed in the fonts
command in the DESC file; if it is not special, there is no need to
list it, since troff can automatically mount it when it's first used.
If the -i option is used, hpftodit will automatically generate an
italic correction, a left italic correction and a subscript correction
for each character (the significance of these parameters is explained
OPTIONS-v Print the version number.
-s The font is special. The effect of this option is to add the
special command to the font file.
-in Generate an italic correction for each character so that the
character's width plus the character's italic correction is
equal to n design units plus the amount by which the right edge
of the character's bounding is to the right of the character's
origin. If this would result in a negative italic correction,
use a zero italic correction instead. There are 8782 design
units per em for Intellifont fonts.
Also generate a subscript correction equal to the product of the
tangent of the slant of the font and four fifths of the x-height
of the font. If this would result in a subscript correction
greater than the italic correction, use a subscript correction
equal to the italic correction instead.
Also generate a left italic correction for each character equal
to n design units plus the amount by which the left edge of the
character's bounding box is to the left of the character's ori‐
gin. The left italic correction may be negative.
This option is normally needed only with italic (or oblique)
Device description file.
Font description file for font F.
This program was written without the benefit of complete, official doc‐
umentation on the tagged font metric format. It is therefore likely
that it will fail to work on tfm files that are dissimilar to those for
the internal fonts on the Laserjet 4, with which it was tested:
TrueType tfm files are not supported.
SEE ALSOgroff(1), grolj4(1), groff_font(5)Groff Version 1.17.2 27 June 2001 HPFTODIT(1)