ESP(4) OpenBSD Programmer's Manual (SPARC64) ESP(4)NAME
esp - ESP NCR 53c94 on-board or SBus SCSI interface
SYNOPSIS
dma* at sbus? (SBus SCSI)
esp* at dma? (two flavours)
esp* at sbus? (depending on model)
scsibus* at esp?
DESCRIPTION
The esp is an on-board or SBus SCSI controller based on the NCR 53c94
chip, found on some Sun UltraSPARC workstations.
DEVICE FLAGS
Bits 0-15 Disable disconnect/reselect for the corresponding target
Bits 16-31 Disable synchronous negotiation for target "[bit - 16]"
The esp device flags may be OR'd together to enable any combination of
the features listed above. Targets 4 through 7 typically have
disconnect/reselect enabled on the premise that tape devices normally
have one of these targets. Tape devices should be allowed to disconnect
for the SCSI bus to operate acceptably.
SEE ALSOcd(4), ch(4), intro(4), isp(4), sbus(4), scsi(4), sd(4), st(4), uk(4)HISTORY
OpenBSD support for the esp first appeared in OpenBSD 3.0.
OpenBSD 4.9 July 3, 2010 OpenBSD 4.9